View a markdown version of this page

Network settings - Amazon SageMaker Unified Studio
PrerequisitesAdd VPC

Network settings

When you configure VPC networking for your domain, all projects created after the configuration will automatically use the specified VPC. You can choose to update existing projects that do not have a VPC configured — see Update VPC configuration and projects.

VPC configuration applies to the life of a project. VPC connection information can change the VPC itself, the subnets within, or the security group. These changes apply to projects created after the VPC is modified.

Prerequisites

  • Domain administrator permissions for Amazon SageMaker Unified Studio

  • An existing VPC that meets the following requirements:

    • At least 2 private subnets in different Availability Zones

    • DNS hostname and DNS support enabled

    • At least 5 free IP addresses per Amazon SageMaker Unified Studio project

  • Appropriate IAM permissions to access VPC resources

Add VPC

To add a VPC, complete the following steps:

  1. From the domain administration page, choose Settings in the left navigation pane.

  2. In the Networking section, choose Add VPC. IAM-based domains support only one VPC configuration at a time. Identity Center-based domains can have a VPC per Region to support accounts that are associated with the domain.

  3. In the VPC section, choose Select and select the VPC where your compute resources will be housed.

    Note

    If no VPC has been set up for use with Amazon SageMaker Unified Studio, you can choose Create VPC to create a new VPC using AWS CloudFormation.

  4. In the Subnets section, choose Select and select at least two subnets in different Availability Zones.

    Warning

    Your subnets must be private or some functionality will not be available. Select subnets configured with the required VPC endpoints to establish connectivity to AWS services.

  5. In the Security group section, select a security group. If a security group is not selected, the service creates one for the VPC.

  6. Choose Save.

You can now view the configured VPC details in the Networking section of the Settings tab. All new projects created in the domain will use this VPC configuration.